(1) Apply interfacing to the wrong side of back button placket (3cm/1.2” wide).
(2) Sew a regular zig-zag or serge stitch along the raw edges of each back facing.
(3) Fold the 3cm(1.2”) from the raw edge to the wrong side.
Then edgestitch it as shown. Repeat with the other piece.
(4) Make the button holes as shown.
(5) Using your CB (center back line) as a guide, lay your left piece overlapping the right piece
and pin in place. Sew the baste stitch.
(6) Pin and sew the shoulders together with right sides of fabric together.
Serge or zigzag stitch the shoulders together.
(7) Press 1/4′′(1cm) bias bindings in lengthwise.
(8) Fold the extra 0.4”(1cm) binding to the inside of the garment.
Working from the right side of the garment,
pin and sew binding to garment aligning the raw edges as shown.
(9) Trim the edge of seam allowances to make smooth round shape.
(10) And fold the binding to the inside of the garment,
rolling the seam line in slightly to hide it on the inside of the garment.
Fold the raw edge of the binding under along the line you pressed earlier,
and pin this fold to the inside of the neck line. Continue to press the binding to the other side.
Topstitch the binding to the neck line close to the inside fold.
Sewing pattern files from link below 👇
 |
댓글
댓글 쓰기